There seems to be a complete lack of cables designed for people with a single hearing aid, [...]]]> Many hearing aids can handle direct audio input (DAI), often via a “shoe” that attaches to contacts on the aid itself. This shoe then provides a DAI jack (sometimes called a europlug or eurojack) that cables can be plugged into.

There seems to be a complete lack of cables designed for people with a single hearing aid, so one of my upcoming projects will be to convert a Y-cable that can serve two hearing aids into a joint DAI/earphone cable instead.

DAI connector pinout

The DAI connector has the following pinout:

• short/thick pin: ground
• long/thin pin: VDD (apparently — doesn’t seem to actually be connected to anything on a 3.5mm cable)
• short/thin pin: signal

Remember that a standard 3.5mm audio plug has the following pinout:

• tip: left signal
• inner sheath: right signal
• outer sheath: ground

Next stage: connecting an earphone to the plug on one side of the cable, to see if there are any impedance issues, although the cable I am using (an fmGenie one) is a very low-impedance cable because I have an Oticon hearing aid. Measured with a multimeter, it seems to be around 0Ω, so I think that’s good enough for me. I believe attenuated cables have a 330kΩ resistor in series with each signal line (according to Neil Ferguson’s bluetooth hearing aid hack page).

My ultimate goal is to get hold of a DAI jack that I can solder directly to an old earphone, so that I can just plug the spare DAI cable into the earphone directly, almost as if it were a hearing aid itself. Unfortunately, it seems that it is impossible to get hold of such things. According to Connevans, DAI jacks are only custom-made for hearing aid shoes. After some discussion, it seems like I should be able to make one myself though (with some help!) so we shall have to see how that turns out.